How to Use ShowBarn Secret® Powder Coat: A Step-by-Step Guide

How to Use ShowBarn Secret® Powder Coat | Draw It Out® Guide Skip to content

ShowBarn Secret® Guide

How to Use ShowBarn Secret® Powder Coat

Last-minute polish without slick mess. This guide shows you how to apply light, blend fast, and finish clean for a ring-ready coat.

Time: ~6 minutes • Difficulty: Easy • Best for: Spot brightening, oil control, quick ring touch-ups

What it is

ShowBarn Secret® Powder Coat is your fast-finish grooming powder for smoothing, mattifying, and blending—ideal for last-minute touch-ups without wet products.

Rider-first promise: quick steps, clean finish, zero diva routine.

When to use

  • Pre-ring polish: Final pass after brushing to even tone and reduce shine where you don’t want it.
  • Photo day: Tidy sweat marks and blend grooming lines.
  • Hot/sweaty rides: Quick reset on neck, shoulder, girth marks after cooling out.

Always follow label directions. Keep away from eyes and mucous membranes.

Supplies

  • ShowBarn Secret® Powder Coat
  • Microfiber cloth or grooming mitt
  • Soft body brush
  • Towel for hands/tack wipe-down

Step-by-Step

1) Start Clean & Dry

Brush away dust/dander. Work on a dry coat so powder grips evenly.

2) Load Light

Add a small amount to a mitt or cloth. Tap off excess—thin beats thick.

3) Apply With the Grain

Sweep lightly in hair direction over target zones; avoid eyes and nostrils.

4) Back-Brush, Then Lay Flat

Lift with a soft brush to distribute, then brush with the grain to blend and smooth.

5) Spot-Polish

Buff high-shine areas with a clean cloth. Wipe tack contact points to prevent transfer.

6) Touch-Ups

Recheck under ring lights/sun. Reapply sparingly only where needed.

Pro tips

  • Whisper-thin layers: Build gradually; over-application looks dusty under lights.
  • Blend the edges: Back-brush first, then lay flat to erase lines.
  • Keep hands clean: Wipe before bridling or saddling to keep grip true.

Quick FAQs

Can I use it on the face?

Use around—not on—eyes and nostrils. Apply lightly to cheeks/jaw and blend thoroughly.

Will it mark dark coats?

Not when applied thin and blended. If you see residue, brush out and reapply more lightly.

Under tack okay?

Yes, but go light near girth/saddle areas and wipe contact points to reduce transfer.

How do I reset after a long day?

Brush out thoroughly post-ride. Shampoo at next bath to remove any remaining build-up.

Need help? Contact Support or read the full Draw It Out® FAQ.

Safety & Clean-Up

Keep it show-smart: External use only. Avoid eyes and mucous membranes. Keep product away from feed/water. Wash hands before handling tack. Store sealed at room temperature.

More » Less «
  • List
  • Map