MasterMudd: Your Horse's Joint and Muscle Solution

MasterMudd™ Joint & Muscle Solution — Targeted, Calm, Wrap-Friendly | Draw It Out®
ShowBarn Secret® | MasterMudd™

MasterMudd™ Joint & Muscle Solution — Targeted, Calm, Wrap-Friendly

Built for riders who put in real miles: a clean, thin application that fits post-ride resets, pre-ride warm-ups, and wrap routines. Intact skin only. Keep out of eyes. No burn. No sting. No drama.

Jump to

Why Riders Choose MasterMudd™

Targeted Application

Designed for precise, small-area work: knees, hocks, stifles, hamstrings, backs—where your program calls for focus.

Point-and-work

Thin, Clean, Wrap-Friendly

Goes on thin and even. Let it set before bandaging for a clean, confident wrap.

“Sheen” not “frosting”

Calm Care Philosophy

Our system is built around quiet compliance—horses accept care when it doesn’t sting or overwhelm.

No drama

Show-Suitable

Formulated without typical show-restricted ingredients and suitable when used as directed. Always confirm your rules.

Check association rules

How to Use — Simple, Repeatable

  1. Clean & Dry: Brush off dirt/sweat; work on intact, dry skin only.
  2. Apply Thin: Use a small amount and massage into the target area until you see a light sheen.
  3. Let It Set: Allow to dry before you ride, tack, or wrap.
  4. Program Order: Whole-body cool first (IceBath™ 1:10 sponge or RTU), then targeted MasterMudd™, then—if desired—finish with thin, even DiO Gel support.

Keep products out of eyes and off open/deep wounds. External use only.

When to Reach For It

Scenario How We Play It Notes
After a hard school Cool whole-body → MasterMudd™ to focused joints/muscles → optional thin Gel support Let each step dry fully
Pre-ride warm-up Light, targeted application to big movers (e.g., stifles, hamstrings, back) Apply early so it’s set before you tack
Travel day stiffness Walk out 10 min → cool pass → targeted MasterMudd™ Hydration matters—offer electrolytes per label with a second plain bucket
Cold weather Shorten wet cooling; lean on targeted application + thin Gel Avoid chills; towel dry
Consistency beats intensity

Standing Wraps — Smart, Not Heavy

  • Apply a thin, even coat and allow to set ~60 seconds before bandaging.
  • Use clean quilts; even tension from mid-cannon down and back up; no rope lines.
  • Recheck at ~12 hours. Change if damp or dirty.
  • One wrap medium at a time: do not layer liniment/solution under poultice.

How It Compares

Topic Typical “Hot” Rubs MasterMudd™ Joint & Muscle Solution
Sensation Noticeable “feel” that some horses resist Calm application designed for quiet compliance
Application Often heavy; can gum under wraps Thin, precise; wrap-friendly when set
Routine Fit Focus on “feel” Focus on results you don’t have to feel: clean, calm care
Show Week Strong scent/feel may not be ideal Scent-neutral mindset; always check current rules

Safety & Straight Talk

  • Use on intact, clean, dry skin only. Keep out of eyes and off open/deep wounds.
  • External use only. Wash hands after use; wipe spills.
  • Products support comfort and routine—they don’t replace diagnosis or veterinary care.

FAQ

Can I wrap over MasterMudd™?
Yes—apply a thin coat, let it set, then use clean quilts and even tension. Recheck at ~12 hours.
Pre-ride or post-ride?
Both. For pre-ride, apply early so it’s set before you tack. For post-ride, cool first, then apply to target zones.
Show-suitable?
Formulated without typical show-restricted ingredients and suitable when used as directed. Always check your discipline’s current rules.
Can I layer it with other Draw It Out® steps?
Yes—common order is: whole-body cool with IceBath™ → targeted MasterMudd™ → thin, even DiO Gel if your program calls for it. Let each step dry.
Eyes or open wounds?
No. Keep all topicals out of eyes and off open/deep wounds. If accidental contact occurs, rinse with clean water and consult your veterinarian as needed.

Brand DNA: Loyalty · Innovation · Story · Deep Care. Ride hard. Care steady.

Targeted Support that Fits Your Program

More » Less «
  • List
  • Map